380 Series: Explosion Proof Locations
T-8 Four Foot Four Lamp Explosion Proof Fixture
The 380 Series is a must for any Explosive Atmosphere Location! (see listings below) This product has five different hub entries at each end enabling the installer to wire the fixture for more desirable angles than a single entry. The center located ballast allows for a more balanced fixture for ease of installation and weight distribution.
UL 844 listed and labeled - Hazardous Locations:
Class I, Division 1, Groups C and D; Class I, Division 2, Groups A, B, C and D
Class II, Division1 and 2, Groups E, F and G; Class III.
UL 1598A listed and labeled - marine type lighting fixture. Outside Type (salt water)
UL 1598A testing equivalent to NEMA 4X requirements for hose-down and corrosion resistance.
UL listed 1598
UL listed and labeled for use inside paint spray booths and rooms.
Also meets requirements for National Fire Protection Association Standard 33
and National Electrical Code Article 516.
UL C approved and labeled Class I, Division 1, Group C and D
Class I, Division 2, Groups A, B, C and D
Class II, Division 1 and 2, Groups E, F and G; Class III.
NEMA 3, 4X, 7CD, 9EFG.
Simultaneous presence Class I and II
Suitable for use inside paint spray booths.
Class I, Zone 1, Group II A
Class I, Zone 1, Group II B
Factory Sealed, Cast Natural Aluminum (U.S. Foundry) that is lightweight
Ballast mounted in the center for better balance and low profile.
(5) 1/2” NPT Hubs located at 0°, 45° and 90° angles.
One piece painted aluminum reflector with 93% reflective white finish
3/16” Clear tempered glass tubes
120-277 Volt (T5, T5HO & T8 only)
120 Volts (T8HO, T12, & T12HO)
220 Volts 50 Hz (T12)
277 Volts (T8HO, T12, & T12HO)
347 Volts (T8 & 4 Ft. T12 only)
Hazardous locations, Paint spray booth, Marine/shipboard, Chemical Manufacturers
Oil Drilling Rigs, Gas Processing Plants, Refineries
All Options Ordered Separately
Optional Polycarbonate Shield and Stainless Steel Guard.
EM: Emergency Battery Backup Ballast
120 or 277V MUST SPECIFY
HB: 93% Reflective specular reflector insert
NOTE: 4 Lamp Mounting Bracket must be factory installed and purchased at the same time as lighting fixtures.
The 380 Series is available in 2' & 4' lengths for 2, 3, & 4 lamp combinations in T5, T5HO, T8, T8HO,
T12 & T12HO. Lamps included.